DAS NX-148E LCD Codepad Manuale Utente Scaricare il pdf (Pagina 9)

Type code to

Disarm

DISARMING THE SYSTEM

When you enter the protected area through one of the designated Entry/Exit

doors, the keypad control will sound a continuous tone for the duration of the

entry delay time, or until you enter a valid code.

# Enter a valid user code.

# The red armed light will go off and

the tone will stop. The security

system is now DISARMED. If a valid code is not entered before the end

of the entry delay, an alarm will occur. NOTE: If the red armed light is

flashing during the entry delay, the alarm system has been activated in

your absence. Leave the building immediately and call your alarm

company and/or the police from a safe location.

BYPASSING ZONES

If you wish to bypass one or more zones, this must be done while the system

is in the disarmed state. If the zone is not known, refer to Procedure #2.

Procedure #1: If you know the number of the zone to bypass, use the following

steps:

Step 1 Press the [BYPASS] key.

Step 2 When the LCD prompts for a code (optional, if programmed),

enter your user code.

Step 3 The bypass light flashes.

Step 4 Enter 1 or 2 digits indicating the zone you wish to bypass.

(Example: Press the keys for zone 1, or for zone0 1 1 2

12.)

Step 5 Repeat step 4 for any other zone(s) that need to be bypassed.

Step 6 Press the [BYPASS] key again to exit the Bypass Mode. The

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 32 33

Nessun commento

DAS NX-148E LCD Codepad Manuale Utente Pagina 9