DAS NX-148E LCD Codepad Manuale Utente Scaricare il pdf (Pagina 16)

ASSIGNING USER CODE AUTHORITY LEVELS

Assign authority levels to users by following the steps below. Assign user

codes before assigning authority levels. NOTE: You must have authority to

the partition you wish to add or remove from another person’s authority.

Step 1 Press . The LCD Screen will now prompt for a code.r 6

Step 2 Enter [master code]. The LCD Screen will prompt for a user

number.

Step 3 Enter the 2 digit user number (always 2 digits, i.e. "03" for user 3).

The LCD will now prompt you for the attributes in the following

chart.

PROMPT

Outputs used? »» DO NOT CHANGE THIS SEGMENT!

Open / Close Rprt? (It is for use by a professional installer only.)

Bypass enable?

Arm / Disarm?

Master code?

0=No 1=Yes

Your key-press will apply to the user code you entered in

Step 3.

Sched arm only?

Arm only?

Reserved

Output 4 ?

If these messages appear on the LCD screen, press the [rr]

key until you return to the prompt for the user code or until

you exit this adjust mode.

Output 3 ?

Output 2 ?

Output 1?

Step 4 NOTE: The LCD will now display all of the partitions to which this user

has access. If you wish to remove a partition, press the partition

number on the code pad, and the display will mark that partition with

a (-) hyphen indicating access has been removed. If you wish to re-

establish user access to the partition, press the partition number

again.

Step 5 Press [rr] to save the data. The LCD will then prompt you for the next

user code.

Step 6 If another user code needs to be programmed, return to Step 3. If not,

press [#] to exit this feature without saving the data.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

Nessun commento

DAS NX-148E LCD Codepad Manuale Utente Pagina 16